Skateboard Stops – Machined Stainless Steel
The damage caused by skateboarders will grind to a halt when they discover you have installed our Skateboard Stop Buttons
Damage to valuable community assets caused by inappropriate use of skateboards is a major problem. It leaves unsightly and often dangerous exposed edges to masonry along with damage to expensive street furniture. Skateboard Stop Buttons can help prevent this damage and alleviate costly repair bills.
Our skateboard stop buttons are of the highest possible quality being machined from solid marine grade 316 stainless steel, unlike some that are made from inferior brittle castings.
Available in seven styles and two sizes for different applications. They are economical to buy and simple to install using basic tools that are readily available to most maintenance and installation contractors.
Installation of Skateboard stops into masonry surfaces
- Set out skateboard stop positions as required keeping approximately 50mm in from edges and spaced no more than 750mm apart.
- Using the appropriate tools, drill holes as set out below:
Models SK20D-SS, SK20F-SS and SK23R-SS drill a 10mm dia hole 30mm deep. Models SK30D-SS, SK30DC-SS, SK30F-SS and SK30FC-SS drill a 12mm dia hole 40mm deep. - Ensure holes are free of dust and half fill with a suitable injectable two-part epoxy.
- Using a twisting motion insert the Skateboard stop down fully into the epoxy, wipe off any excess epoxy before it cures.
Care should be taken in determining the appropriate off-set of the skate deterrent button from the edge of the seat or wall to prevent cracking or damage of the substrate material during installation.
Note: Always use appropriate personal protective equipment when using power tools or chemicals.
Skateboard Stops
1 to 8 of 8 results1 to 8 of 8 resultsDescription: Skateboard stop buttons. Material: Solid marine grade 316 stainless steel. Finish: High quality satin polish. Styles: Round ball, Dome and Flat top. Above Ground: SK20D-SS 10mm
SK20F-SS 10mm
SK23R-SS 23mm
SK30D-SS 15mm
SK30DC-SS 19mm
SK30F-SS 15mm
SK30FC-SS 19mmBelow Ground: SK20D-SS 25mm
SK20F-SS 25mm
SK23R-SS 25mm
SK30D-SS 35mm
SK30DC-SS 31mm
SK30F-SS 35mm
SK30FC-SS 31mmInstallation: Epoxy adhesive into drilled hole. - Sorry, we currently don't have any Case Studies related to this product.
- Sorry, there are no Just Ask Questions for this product. Would you like to ask one?
- We are currently compiling a list of additional services that might apply to this product.
